GlassGuardWindow FilmCall 905-330-3802Get a free quote

of 05 film types

Helps hold broken glass in place; can help delay entry

Security window film

Thick, tear-resistant film that keeps broken glass in the frame and helps slow a smash-and-grab.

Ground-floor shop window in a brick storefront
Applied to
Interior glass surfaceOptional frame attachment
Thickness
14 milThe security film we quote
UV
Up to 99%Per manufacturer data sheet
Purpose
Delay, not stopPair with locks and alarms

What it is

Helps hold broken glass in place; can help delay entry.

Security film is thicker than safety film and built for tear and impact resistance. When the glass is struck, the film holds the pieces together so the pane tends to stay in the frame instead of falling away.

It does not make glass unbreakable, and it is not ballistic armour. What it does is buy time: a struck pane that stays in the frame takes longer to get through. It works best alongside good locks, lighting, and an alarm or camera system. With an attachment system that bonds the film to the frame, glass stays in place better still.

What it does

At the glass

Holds glass
Broken glass stays bonded to the film instead of falling out of the frame.
Can help delay entry
Can make a quick smash slower. Results depend on the glass, frame and tools used.
Reduces shards
Limits flying glass from storms, accidents and impacts.
Stays clear
Most security films are clear, so the storefront or view is unchanged.

The film we install

Madico Clear 14 Mil

Our 14 mil security film is Madico Clear 14 Mil: a clear multi-ply film. See its data sheet figures, DOWSIL 995 frame anchoring, Madico's warranty terms and a tool to measure your glass.

Madico 14 mil security film

See it

Struck glass, with and without film.

Click or tap the glass, or focus it and press Enter or Space. With film, strike after strike only cracks and shatters the glass; one small hole opens near the end, and the film still holds the glass. Then switch to No film and strike again to compare.

The view from outside, at night: a warmly lit room where a TV, a laptop, a purse and a jewelry box can be seen through the glass. Strike the pane with the hammer to see what happens next.

NoteIllustration, not a test result. The cracks are drawn by code, and the number of strikes is not a measured figure for any glass or film.

Security film (14 mil in our quotes) and safety film (8 mil) are clear polyester layers bonded to the glass. When the glass is struck it still cracks, but the film helps hold the broken pieces together, so they are less likely to fall out of the frame or scatter.

This is an illustration of that behaviour, not a laboratory test, not a performance grade and not a promise of break-in prevention. Real performance depends on the glass, the frame, how the film is attached and the installation.

Strike by strike: with film and without

The same pane, struck again and again. The stage you have reached in the simulator is marked below. This is an illustration, so the number of strikes is not a measured figure.

  1. Strike 1

    With filmThe glass cracks and a spiderweb of cracks forms around the impact. No holes: the film holds the glass in the frame.

    No filmThe glass cracks and small flecks of glass chip off at the impact point.

  2. Strike 2

    With filmA second spiderweb of cracks forms. Still no holes, and the glass stays in the frame.

    No filmThe pieces around the impact fall out of the frame.

  3. Strike 3

    With filmMore cracks spread and join up across the pane. Still no holes, and the film still holds the glass.

    No filmThe broken glass falls out of the frame and the opening is clear.

  4. Strikes 4 to 12

    With filmThe web of cracks gets denser until it covers the pane. At the 10th strike one small hole opens at that impact point, and the 11th and 12th make it a little bigger. The film still holds the glass.

    No filmThe frame is already empty, so there is nothing left to strike.

Safety film (8 mil) and security film (14 mil in our quotes) are both clear films that bond to the glass. Real results depend on the glass, the frame, how the film is attached and the installation.

Where it goes

Typical openings

  1. Retail storefronts and display windows

  2. Ground-floor patio and sliding doors

  3. Sidelights next to door locks

  4. Basement and out-of-sight windows

  5. Offices with street-level glass

FAQ

Security film questions

Does security film stop a break-in?

It will not make glass unbreakable. It holds shattered glass together in one sheet instead of letting it fall away, which can help delay forced entry.

How thick is security film compared to regular tint?

Considerably thicker. Security films are built in multiple layers for tear and impact resistance rather than looks. We will show you the thickness of the specific film we recommend.

Will security film stop a bullet or a sledgehammer?

No. It is a delay layer, not ballistic-rated armour. It is designed to slow forced entry and is best paired with good locks and monitoring, not used in place of them.

Next step

Get a free security film quote.

We measure on site, check the glass and show samples on your own windows. Call, or send a few photos and we will come back to you.

Call

905-330-3802